Replace
your OEM system with the advantage of a reliable
wrenchless system that works smoother and is easier to
maintain and clean.
This simple 2 piece design bolts together
for quick installation, cleaning, and replacement.
On standard wrench style systems,
personnel may fail to tighten the bolts adequately after
set up and the collar will work itself loose and
possibly fall into the machine causing major damage to
printing dies and printing cylinders. Our system
prevents damage because the collar automatically locks
when released in the new position because you simply
twist and pull to the new location and release. Teeth
reengage holding collar
in place.
|
Its Poly-On Teflon impregnated coating
inside and out provides a hard non-stick surface. The
collars slide smoothly and cleanly along the shaft.
Our non stick rack gear which is also
Poly-On coated can be mounted to any pull collar shaft,
whether keyed, non-keyed or OEM style rack gear shaft.
Initial installation can be completed
within 4 hours by your in house maintenance personnel.
A low profile center board support collar
is also available.
|
Our
quick change crush collars are made with the same
quality as our pull collars. Again, this is a 2 piece design that bolts together for quick installation,
cleaning, and replacement. The twist and release
feature prevents possible damage to costly equipment
from loose collars that fall into machinery.
You can convert your wrench style crush
collar to our convenient wrenchless style or we can
duplicate the OEM autoset style with the advantage of
the Poly-On Teflon coating for a smoother, cleaner
surface, all at a reduced cost. |
